Click Male to reduce the low end somewhat to minimize p-popping and booming note that it also helps even out the level variations a bit.Click an effect insert’s right arrow, and choose Special > Vocal Enhancer.Choose File > Open, navigate to the Lesson04 folder, and open the file NarrationNeedsHelp.wav.The Vocal Enhancer effect is one of Audition’s easiest effects to use because it has only three options. There’s no disadvantage to leaving it on. Leave Post-Filter DC Offset selected because it can prevent the addition of a constant offset that can lead to clicks when you’re editing. Linear scale changes the calibration logarithmic more closely approximates the way the ear responds. Regarding the other Distortion parameters, dB Range changes the range covered by the graph and limits possible distortion settings to the selected range. Processing a bass with a hint of distortion can help it stand out more in a mix. Note how the smoothing creates a softer kind of distortion quality that gives the bass a bit of “snarl” but still sounds musical. Choose a value of 30%, and then bypass/enable the distortion to compare the distorted and undistorted sound. The reason is that the Time Smoothing parameter changes the distortion’s reaction time to level changes, particularly at lower frequencies. Increase Time Smoothing, and the distortion becomes smoother and less harsh.This adds crunch but also preserves the “fullness” of the bass by leaving one set of peaks alone. With the graphs unlinked, bring the upper-right square for one of the graphs down to -20dB. If the graphs are still linked, you’ll reset them both simultaneously otherwise, you’d need to reset them individually. Click a graph’s reset button (the spiral arrow).When there are multiple nodes, you can smooth the curve that incorporates them by increasing the Curve Smoothing parameter value. Continue adding and moving nodes to hear how this affects the sound. To remove a node, right-click (Control-click) on it. Dragging the node to the left also increases distortion by allowing lower levels to distort. Drag this new node up to increase the volume of low-level signals, thus creating more distortion.Boosting lower levels causes them to distort more readily.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |